Laerdal HeartStart AED Trainer - Manual (Page 15)

14
A
B C D
E F
Repacking the Training Cartridge
After you have finished using the training pads cartridge, press and hold the
green On/Off button to turn off the Trainer. If battery power is low after
training, the Trainer will tell you to replace the batteries.
Prepare the training pads cartridge for its next use as follows:
1. Turn off the Trainer.
NOTE:The following steps can be performed as illustrated or with the training pads
cartridge in the Trainer.
2. Reapply the pads to each side of the
solid yellow liner, making sure that
the red tabs are positioned at same
end of the liner as the yellow tab (A)
and that neither pad extends beyond
the edge of the liner.
3. Press the pads firmly together on the yellow liner.
4. Untwist the wires, then wind the wires around the training cartridge
recess, pressing them into the track (B).Then place the pads over the
wound wires in the cartridge.The chest pad should be on top, and the
tab ends of the pads at the curved end of the cartridge (C). Fold the tab
down over the top pad (D).
5. Press the resealable film cover over
the cartridge, with the tab end
at the top (E). Be sure to fold
the tab back down under
the cover (F).
HeartSart trainer DfU 5681 C.qxd 14-11-06 15:20 Page 14
Copy Approved - Check Revision Before Use