Laerdal SimView - Manual (Page 11)

11
4.7.2 Non SimMan3G setup
The setup for SimMan, SimMom, SimJunior Advanced, SimNewB Advanced for SimPad, ALS Advanced for
SimPad, SimJunior for SimPad and SimBaby is different as seen on the next illustration
Figure 12 The SimMan setup
Tip! If you experience connection problems between the Instructor Application and SimView, after the
setup, make sure that the Laerdal SimView Extension Service is started, and configured properly. You can
check by using the Component Services tool. Go to the Start menu and write services in the search field;
select the Component Service. Under the Services (Local) you should see Laerdal SimView Extension
Service. If the status is not running, then press the Start button in the top left side of the services listing.
You can also use the SimView Extension to check the connection and the service, as both will be checked
when the Test connection is used.
5 SimView
Software installation 5.1
The SimView server PC will be supplied with the software pre-installed.
The first time you want to access SimView, you can do so by following these steps:
A default administrator user is already created with the following login information:
User: admin
Password: Laerdal1
Important! You should change the password for this user once you are ready to use the system!
On the desktop you will see the SimView application icon.
To start the SimView double click the SimView icon on the desktop: