Laerdal SimView - Manual (Page 9)

9
For more information on the recording procedure see chapter 6.6 Recording using LLEAP.
Legacy Instructor Applications integration with SimView Extension 4.6
If you are using SimView with legacy Instructor Applications, like SimMan, SimMan3G etc. you must install
the SimView Extension Configuration tool on the PC running the Instru ctor Application and
configure it according to your needs and the guideline described in this guide.
This is also the process you need to perform if you have updated from AVS. The video settings in the
Instructor Applications have to be changed in order to use SimView instead of AVS Video Server. If you
should want to use AVS again, just change the video setting back to the old values and remove legacy
support in SimView Extension, see Figure 8.
You can use the IP address or the name you have entered as the Computer name in the Control panel
instead of the IP address, see chapter 4.1.
Use the Test connection button to make sure you have the correct server address, then press Save and
close.
Note! SimView Extension must be installed after all other Laerdal software like the simulators SimMan3G,
SimMan etc. and the Laerdal Debrief Viewer.
Note! After reinstalling or upgrading your Instructor application, you must reinstall the SimView Extension
program.
Figure 8 The SimView Extension setup windows
Legacy simulator setups for use with SimView: 4.7
The setup for the different types of simulators is shown in the next two chapters.
4.7.1 Setting up SimMan3G and SimMan Essential:
SimMan3G and SimMan Essential use the same setup.
The next two pictures show how to setup the service.
Figure 9 SimMan3G Extension Service, select the Profile Editor