Datamax PE - Manual (Page 19)

PE Series Operator’s Manual 9
Setting Up the Printer
3.0 Introduction
This chapter explains how to connect the printer to the host, load
media and print a configuration label.
3.1 Connecting the Printer
; Note: Ensure that the printer’s power switch is ‘off’ when
connecting the AC power cord or any interface cable.
Connect the AC power cord to the back of the printer before plugging
into a properly grounded outlet. The printer can be connected to the
host computer with a parallel or serial cable, (see Appendix C). The
applicator connections should also be made at this time. The figure
below shows the position of the interface ports.
Figure 3-1 Connecting the Printer