Legacy Audio Point One - Manual (Page 11)

11
Once you’ve found a place in your room, the next step is connecting the
Point One to your existing system. Listed below you will find 5 options.
Option 1: Connecting the Point One using the LFE input.
If your preamplifier/digital processor/receiver has a subwoofer output, it
can be connected (via RCA cable) directly to the LFE (Low Frequency
Effects) input (fig. 1).The LFE input bypasses the subwoofers internal
crossover and allows you to control your low frequency settings
(Frequency, Level) from your preamp.
NOTE: When using the LFE input, the freq. control on
the front panel of the Point One will be bypassed. The
level control will then function as a sensitivity control,
allowing the preamp/processor to control volume.
Speaker Connections