Legacy Audio Point One - Manual (Page 14)

14
Powering Up Point One
1. Power Cable: The supplied power cable will plug into the socket on the back terminal
plate of the unit.
NOTE: Try to plug into the same AC circuit as the rest of your audio system, as this will avoid
hum from ground loops.
2. Power Up: In the rear of the subwoofer to the immediate left of the power cable input is
the power switch. This switch controls current flow to the entire unit as follows:
I = on
0 = off
Off/Auto On switch: This switch starts or stops signal flow to the unit. In
Standby the preamp unit stays active but the amplifier shuts down.
Auto On: Once bass signal is received, Point One will turn on automatically. If the unit has
not received a bass signal after 30 minutes, Point One will mute.
Off: Will manually set unit to mute (standby)
NOTE: Be sure the front panel switch is in the OFF position before flipping the rear panel
power switch. This will avoid unnecessary transients through the subwoofer. In either Auto
On or Off position the LED display will remain lit. Only when the rear power switch is in the
off position, will the LED go off.
Speaker Connections