Legacy Audio Whisper XDS - Manual (Page 17)

17
The XD processor will allow you to make adjustments to your system from a laptop computer
from your listener position.
Connecting Your Computer with the Xilica Processor
- Connecting will require a long USB Device cable. These can be found at most electronic or big box stores. It is the
same cable that a USB printer would use. This 16 ft cable is available at Radio Shack.
http://www.radioshack.com/product/index.jsp?productId=3584358&filterName=Length&filterValue=16-20+ft .
- Once the cable is connected, start the XConsole software. It will ask “Do you want to connect to the device?”, answer
“No” for now.
- You now must access the Windows Device Manager. This processes can vary depending on the version of Windows in
use, but typically it is found in the Control Panel. Then click on “System.” On the tabs across the top, click “Hardware”
and then “Device Manager” This will bring up a list, find “Ports (COM & LPT)” and click the plus (+) next to it. You
should then find a device called “Silicon Labs CP210x USB to UART Bridge” with a COM number listed next to it. This
number will change on all computers, but take note of this number.
CONTINUED ON NEXT PAGE
Whisper Wave Launch Processor