LG Motorsports LG C5 GT2 Coil Overs - Manual (Page 8)

With the lower control arm dropped you can slide the coil over in place and
secure the upper mount first before placing the lower fork mount over the lower control
arm. When sliding the shock in place, make sure the cable adjuster is on, and tight to the
knob. Make sure all set screws are locked down in place as you will not be able to reach
them once it is in place. Route the cable through the upper hole and towards the rear so
you can reach it once the shock is in place. Tighten down the upper mount completely
before going further.
Figure 14a and 14b: Install of rear coil over
Finish the install by installing sway bar end links, and making sure all mounts,
nuts, bolts, are tight. Also make sure that all wires, and fluid lines are clear of the springs
and shocks so that they are not pinched.
Once everything is set, before you put the tires back on, please take a moment to
use your spanner wrenches and double check all of your lock nuts at both the spring and
the shock body to make sure they are tight. Also check shock settings and they are at the
desired setting. See figures 15a and b.
Figure 15a and 15b: Setting heights and tighten lock rings.