LG Motorsports LG C5 Pro Long Tube Headers - Manual (Page 4)

Figure 2: X-pipe location with hole drilled for 02 sensor wires (front is to the right).
At this point the rest of the system can be loosely hung into place. The installed system
should look like the picture in Figure 4.
Figure 3: Assembled system (off-road shown).
Before final tighten of all of the clamps care must be taken to insure that all pipes
are located correctly taking special care to note placement of the rear pipes as they go
over the rear end of the car. While tightening the exhaust clamps down make sure that
each clamp is clear of the frame rails, and each other. Special care must be taken on the
clamps around the X pipe as they can rotate too far and the bolt will rattle on the center
plate support. Once the install is complete please give the exhaust a once over and make
sure no pipes are touching, clamps are free of each other and that the bolts are not making
contact with any part of the car.