LG Motorsports LG C6 Carbon Side Skirts - Manual (Page 3)

Once the area is clean you will need to remove both rear wheels to access the inner wheel
well for install of the mud flaps. You will need to remove one of the factory screws in
the inner wheel well by the rocker panel. This will attach the flap and locate it on the car
before you drill and mount the remaining points.
Figure 3: Removal of rear wheel and install of ‘mud flap’
Once you have the one bolt in the flap you will now start by mocking up the rocker panel.
You will start by removing two screws at the front fender under the car and these will be
used to locate the rocker to the car. Lay the rocker panel up against the car and start the
two screws at the front. DO NOT TIGHTEN THESE YET!
Figure 4: Starting Rocker Install
Now that the mud flap and rocker are loosely lined up on the car you will need to attach
the rocker panel to the mud flap at the lower point. You will see two holes in the flap and
two holes in the rocker panel already there. Use the two supplied 3/16” rivets with back
up washer on the inside rivet. Go ahead and snap the rivets in place at this time with a
hand held rivet gun.