LG Motorsports LG Gen5 Short Shifter User Manual
Page 4
Figure 5a and 5b: removing dust boot and pivot rod
Now that the boot is removed you will need to remove one of the two clips
holding the pivot pin in place. This can be done with a long flat screw driver, or your
fingers. Once this is out, slide the rod out and the shift lever is now free. This is easiest
to remove with the transmission in N. There are now just two 10mm head screws
holding the shift lever in place. You will need a 10mm socket, swivel and extension to
reach this. Make sure not to lose the screws when they come out. The lever will now
come out through the bottom of the car. You may want to push down from the top side to
un-seat the pivot bearing. See Figures 6 through 10 below for details.
Figure 6: Pivot rod clip