LG Motorsports LG Gen5 Short Shifter - Manual (Page 7)

Now you are ready to install the shifter back into the car. Install is going to be
basically the reverse of your removal. Start by installing the shifter from the bottom side
of the car, and replacing the two screws removed on the plate. Line up the shift rod and
re-install the shift level pin and clips. Once this is done, pull the dust boot back up and
over the shifter box assembly and you can enter the inside of the car to finish up the boot
and trim panel install and top off with your shift knob!
Figure 12a and 12b: New shifter install and boot replacement
Figure 13a and 13b: Install of shifter knob
THREADED KNOB VERSION
Please note: if you purchased a threaded shifter version, the knob will screw on, and you
will tighten until the knob stops. You will have to flip the boot inside out and cut the
factory zip tie holding the boot to the trim piece. Before install you may want to zip tie
the boot to the lower ring of the shift knob prior to install of the knob or lower leather
boot assembly for ease of install.