Lingenfelter L330030709 CTSV High Flow Intercooler Pump Upgrade Kit v1.0 - Manual (Page 6)

Page 5.
9. Disconnect the harness connector that is
located behind the factory intercooler pump
mounting bracket.
10. Using hose plugs, cap off the intercooler
hoses.
11. Using a small pry tool or flat head screwdriver,
remove the wire loom retaining clip from the
factory mounting bracket. The location of
the wire loom retaining clip is shown by the
red arrow in the adjacent illustration. Next,
remove the factory intercooler pump harness
from the vehicle.
12. Install the supplied wire loom retaining clip
onto the supplied VariMax intercooler pump
wiring harness by sliding it onto the connector,
as shown by the red arrow in the adjacent
illustration.