Lingenfelter L460135297 Lingenfelter LNC-TC1 Torque Cut Module RPM Limit v1.1 - Manual (Page 10)

Page 9
Setting the torque cut:
• Kill Enable Offset Voltage
Required change in load cell voltage 0 – E: Change in voltage the LNC-TC1 needs to see before
activating torque kill.
Position Voltage Change
0 ........................... 0.2 V
1 ........................... 0.3 V
2 ........................... 0.4 V
3 ........................... 0.5 V
4 ........................... 0.6 V
5 ........................... 0.7 V
6 ........................... 0.8 V
7 ........................... 0.9 V
8 ........................... 1.0 V
9 ........................... 1.1 V
A ........................... 1.2 V
B ........................... 1.3 V
C ........................... 1.4 V
D ........................... 1.5 V
E ........................... 1.6 V
F ........................... ALT 1
1 Position F for the Kill Enable Offset Voltage is used for manually cutting torque either with a momentary
switch or some other external device. The alternate setting must receive 5-12 volt DC to cut torque.
• Kill Time
Torque kill time settings 0-E: Sets the time that the torque kill is activated during shifts in
milliseconds (0.001 seconds).
Position Kill Time
0 ........................... 25 ms
1 ........................... 30 ms
2 ........................... 35 ms
3 ........................... 40 ms
4 ........................... 45 ms
5 ........................... 50 ms
6 ........................... 55 ms
7 ........................... 60 ms
8 ........................... 65 ms
9 ........................... 70 ms
A ........................... 75 ms
B ........................... 80 ms
C ........................... 85 ms
D ........................... 90 ms
E ........................... 95 ms
F ........................... OFF 2
2 Position F for the Kill Time setting is used to cut the torque for as long as the signal meets the required
setting for the load cell range. This is the normal setting for external torque cut control. If the load cell
voltage is met on the torque cut module for a given time, the torque cut will happen over the entire time
the load is applied.