Lingenfelter L460135297 Lingenfelter LNC-TC1 Torque Cut Module RPM Limit v1.1 - Manual (Page 3)

Page 2
LNC-TC1 Specifications:
• Custom molded high temperature glass filled Nylon 6 enclosure with direct access to the controller settings
without requiring removal of a cover or access panel.
• 40 MHz 16-bit automotive qualified processor with eight channel Enhanced Time Module.
• Each coil drive circuit has a dedicated timer to keep the timing accurate over the full RPM range.
• Independent coil drive provides Sequential Ignition Kill when RPM limiting is active.
• Reverse battery protection.
• Both of the activation inputs have active clamps and optical isolation to suppress electrical noise from
external solenoids (such as trans brake and line lock).
• Digital filter provided in software to further isolate electrical noise on the activation inputs.
• Separate RPM x100 and RPM x1000 switches for easy setting adjustments.
• RPM limiter activation point can be adjusted from 1500 to 9,900 RPM in 100 RPM increments.
• Both Ground Activation and +12 Volt Activation inputs are provided for RPM limit activation.
• Load cell inputs allow for adjustable torque cut based on load cell voltage.
• Torque cut time ranging from 25ms to 95ms.
• Alternate setting to allow for manual control of torque cut with momentary switch, seperate controller, etc.
• Analog voltage output wire for sending torque cut signal to data acquisition systems (EFILive, HPTuners,
DashDAQ, Racepak, AEM, AIM, etc.).
• True plug-and-play coil pack connection design for ease of installation and removal.
• Fully encapsulated (potted) construction for added durability.
• One year warranty (from date of purchase).