LINK Systems Microlink - Manual (Page 14)

MicroLink: Operator Interface Terminal
Manual Revision 1.0 4/20/99 4-2
supervisor to configure the access code system.
See Chapter 6 for more information.
Pressing the “Serial Ports ” soft key brings up a
screen similar to Figure 4.2. This screen shows
each of the five communication ports in the
MicroLink unit. The soft keys on this screen are
used to configure the communication tasks, such
as a roll feed interface, a LinkNet connection, or a
programmable logic controller (PLC) interface.
See the feed manual or the LinkNet manual for
more information. Contact Link Systems for other
applications.
The MultiSet system has separate configuration
and calibration procedures. See the MultiSet
manual for more information.
Figure 4.2: Communications Setup Screen