LINK Systems Microlink - Manual (Page 9)

MicroLink: Operator Interface Terminal
Manual Revision 1.0 4/20/99 3-1
Figure 3.1: Dimensional Drawing for Panel Mount of MicroLink Enclosure
3. INSTALLATION
The first step of the installation of the MicroLink
system is the physical mounting of the unit. The
first two sections of this chapter show the
mounting options. After the mounting is
completed, the necessary wiring can be installed.
The basic wiring for the MicroLink system is
covered in the last section of this chapter. The
wiring for the MultiSet system is covered in the
separate MultiSet manual.
3.1 Mounting the MicroLink Unit
There are two mounting options that allow the
user to match the installation of the unit to their
particular application. The unit can be mounted in
a panel or it can be mounted in a separate
enclosure.
The flush mount option allows the system to be
located in a control enclosure with other press
electrical systems. The advantage of this
mounting arrangement is that all of the press
electrical systems can be located in one central
area for easier operation. Another advantage of
this option is that the system can be installed
within a custom made enclosure. The dimensions
for flush mounting the MicroLink system in a
panel are shown in Figure 3.1.