LINK Systems OmniLink 5000 - Manual (Page 111)

8.3
valve in energized. This fault occurs only if configured for valve monitor type 002 (see section on Valve
Monitor).
"Mode Selected Error"
The two channels of the press control do not agree on the present stroking mode, and the desired mode
must be selected by the operator.
Section 8.2 External Faults
These faults indicate an unacceptable condition with some external device connected to the system 5000.
They do not typically indicate a fault within the press control. The following is a list of these faults:
"ES BUTTON FAULT"
The two emergency stop button contacts (that are wired to the same switch) do not track each within an
allowable time. This indicates a fault in the button, or field wiring.
"L INCH BUTTON FAIL"
The Left Inch Button normally open contact closes without the normally closed path opening. This
indicates a fault in the button or field wiring.
"R INCH BUTTON FAIL"
The Right Inch Button normally open contact closes without the normally closed path opening. This
indicates a fault in the button or field wiring.
"LEFT #1 BUTTON FAIL"
The Station #1 Left Run Button normally open contact closes without the normally closed path opening.
This indicates a fault in the button or field wiring.
"RIGHT #1 BUTTON FAIL"
The Station #1 Right Run Button normally open contact closes without the normally closed path opening.
This indicates a fault in the button or field wiring.
"LEFT #2 BUTTON FAIL"
The Station #2 Left Run Button normally open contact closes without the normally closed path opening.
This indicates a fault in the button or field wiring.
"RIGHT #2 BUTTON FAIL"
The Station #2 Right Run Button normally open contact closes without the normally closed path opening.
This indicates a fault in the button or field wiring.
"LEFT #3 BUTTON FAIL"
The Station #3 Left Run Button normally open contact closes without the normally closed path opening.
This indicates a fault in the button or field wiring.
"RIGHT #3 BUTTON FAIL"