Lumagen Radiance XS-3D - Manual (Page 33)

Section 6 – Audio Configuration
RadianceXS rev 091211 25
•
You can over-ride the global Audio EDID for a particular HDMI input by selecting MENU → Input
→ Audio Setup → Audio EDID → Custom → Ok. Set the audio modes to “Y” (yes) that you
want to report back the source for that input.
•
Audio is muted when changes are detected on the input. Some audio receivers need to be muted
longer to avoid unintended noise. MENU → Input → Audio Setup → Mute Control → Long →
Ok
Audio Menu Navigation
You can change the setting for any item in the Audio menu by first navigating to the item using the
remote’s arrow buttons and then pressing the “OK” button. The item will begin flashing to indicate it is
active for change. Use the arrow buttons to change the setting. Press the “OK” button to accept the setting
or the “EXIT” button to cancel. The highlight will stop flashing and a new item can be selected.
Audio Menu Selections
Each line of the audio menu can have up to 6 entries. These are:
Conditional Audio EDID to Report User Mode Select HDMI1 HDMI2 SPDIF
Always
If Out1 video on
If Out2 video on
Else Merged Out1&Out2 EDID
Out1 EDID
Out2 EDID
User1 EDID
User2 EDID
User3 EDID
PCM 2Ch 44.1Khz
PCM 2Ch 48Khz
PCM 2Ch 96Khz
PCM 2Ch 192Khz
PCM 5.1 44.1Khz
PCM 5.1 48Khz
PCM 5.1 96Khz
PCM 5.1 192Khz
PCM 7.1 44.1Khz
PCM 7.1 48Khz
PCM 7.1 96Khz
PCM 7.1 192Khz
DD 5.1Ch
DD 7.1Ch
DD+ 5.1Ch
DD+ 7.1Ch
DTS 5.1Ch
DTS 7.1Ch
DD HD 5.1Ch
DD HD 7.1Ch
DTS HD 5.1Ch
DTS HD 7.1Ch Y
Y
Y
N
N
N
N
N
N
N
N
N
Y
N
N
N
N
N
N
N
N
N On
Off On
Off On
Off
Audio Menu Structure
Audio setup is global using an “If – Then – Else” structure based on which HDMI output has active video. In
contrast, the video EDID is selected in the input memory “EDID Setup” on a “per-input-memory” basis, and
the audio EDID is globally selected based on which HDMI output has active video. The net effect of this
method is that the video EDID capability can be passed back from one of the HDMI outputs (or user
defined) and the audio EDID capability can be passed back from the same HDMI output, the other HDMI
output (or user defined).
NOTE:
By default, Output 1 has both video and audio enabled, and Output 2 has only video enabled.
So, the default configuration for a system with an AVR and a projector is that the AVR is
connected to Output1 and the projector is connected to Output 2. Examples below illustrate
how to change this if desired.
The “If” Conditional
The first parameter on each command line can be an “Always” clause, an “If” conditional, or an “Else”
clause. If there is more than one line, the last line will always contain an “Else” clause. The “Always” or
“Else” clauses do not have conditionals. There are two options for an “If” conditional:
•
If Output 1 is enabled for video output