Marsh Sound Design P2000-B High Performance Line Amplifier - Manual (Page 3)

Marsh 3
Before proceeding with the installation, please read the instructions carefully and completely. If you have
any problems, do not hesitate to contact your retailer or our Service Department.
1. All warnings on the unit and in the operating manual should be followed.
2. Operate the unit only from a power source of the appropriate voltage indicated on the rear panel.
3. Do not use a damaged or deformed power cord as it may cause electric shock. When removing the plug
from the wall outlet, be sure to remove by holding the plug attachment and not by pulling the cord.
4. This unit should not be used near water or in humid conditions.
5. Do not pour or spill liquids of any kind onto this unit.
6. Do not operate this product with any cover removed.
7. Before connecting or disconnecting any cables, always turn off your equipment and disconnect your
entire system from the AC mains.
8. Do not replace any fuse with a value or type other than that specified.
9. Do not overload the wall outlet or extension cord because this can result in a risk of fire or electric shock.
10. Do not push objects of any kind into this product through the openings e.g., ventilation slots, because
they may touch dangerous voltage points or short-out parts. This act could result in a fire or electric
shock.
11. Do not attempt to repair this product because opening or removing covers may expose you to dangerous
voltage or other hazards. If a problem occurs, contact your Marsh retailer.
12. Disconnect your entire system from the AC mains before cleaning.
13. Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of this
product and to protect it from overheating. These openings must not be blocked or covered.
14. The operating temperature ranges from +5 to +35 degrees C. Operating humidity ranges from 5% to
80%. Do not operate the unit when the temperature and/or humidity are outside of this range.
Important/Precautions