Martin Archery Compound Bow - Manual (Page 6)

SHOOTING STRING
BUSS + SPLIT CABLE
SHOOTING STRING
Adjusting The Silk Cam Draw Weight
To adjust your draw weight, simply use an allen wrench and turn the limb bolts out (counterclockwise) a
MAX of 5 turns. This will decrease draw weight by 15 LBS total. (WARNING: DO NOT UNSCREW LIMB BOLTS MORE
THEN 5 TURNS OR SEVERE INJURY MAY OCCUR) the Draw weight can also be adjusted by moving the string
position for the Buss + Split Cable. The anchor labeled "STND" is your standard designated weight and position.
By moving the cable position to the anchor labeled -1 you decrease the weight by aprox 13 LBS and by mov-
ing your buss positon to the anchor labeled -2 you decrease the weight by another 13 LBS. Draw length will
decrease by 1" for peg -1 and 2" for peg -2. Draw length may need to be re-adjusted by changing the module
position for your desired length.
Front Side
Back Side
The Martin Silk Cam system feature a modular draw length adjustment. The draw length module is
used to adjust draw length in 1/2" increments (see below). Adjusting the draw weight can also be adjusted
by moving the limb bolts out or changing the string position.
Adjusting The Single Cam Draw Length
Using draw length modules, the draw length can
be adjusted in 1" increments. To change the draw
length, replace the module on the cam by removing
the screws that hold it to the cam. NOTE: do not draw
your bow without the module installed. It will damage
your harness.
The module sizes range from A to G. As the
module letters get higher, the draw gets longer.
The draw length can also be adjusted in 1/2" in-
crements using the pegs on the back of the cam.
This method of draw adjustment applies to the
Martin Acu-Trak, Fuzion, Dyna, M-Pro, and M2 Single
Cam System.
Bottom
Cam
Single Cam String Diagram
The string harness on your Single-
Cam is installed according to the dia-
gram below. Your string harness should
be installed by your qualified Martin
dealer.
MODULE
SCREWS
Silk Cam System
Parts Of The Silk Single Cams System
DRAW
STOP
SHOOTING
STRING
ANCHOR
MODULE
SETTING
MARK
STANDARD SPLIT
STRING ANCHOR