Martin Archery Compound Bow - Manual (Page 7)

The Martin Equalizer Cam system features two rotating modules for draw length adjustments in inch increments as
well as let off adjustment. This cam system also features an adjustable draw stop for a customized valley and solid stop.
Parts Of The Equalizer Cam Sytem
MODULE
SCREWS
Bottom Back Cam
Equalizer Cam String Diagram
The string harness on your Equalizer Cam is installed according to the diagram below. Your string harness
should be installed by your qualified Martin dealer.
DRAW
STOP
Shooting String
Split Cable
Adjusting The Equalizer Cam Draw Length
Make a note of the number on the Module by the setting mark. To rotate the draw length mod-
ule, you will first need to remove the two (2) allen head module screws. Lift and rotate the
module to the desired position and replace and tighten the screws in the appropriate
positions on BOTH cams. Draw length is adjusted in one inch increments and is labeled on the module. DO NOT
draw the bow without the draw length module in place and secured.
Adjusting The Equalizer Cam Draw Weight
The draw weight on any Martin bow using the Equalizer cam system can easily be adjusted by moving the
limb bolts out (counterclockwise) a MAX of 5 turns. This will decrease draw weight by 15 LBS total. (WARNING:
DO NOT UNSCREW LIMB BOLTS MORE THEN 5 TURNS OR SEVERE INJURY MAY OCCUR)
DRAW
STOP
MODULE
SETTING
MARK
MODULE
SETTING
MARK
Equalizer Cam System
SPLIT
STRING
ANCHOR
Split Cable
MODULE
SCREWS
SHOOTING
STRING
ANCHOR
Top Back Cam
Top Front Cam Bottom Front Cam
MODULE
SCREWS
DRAW STOP
ADJUSTMENT NUT
The equalizer cam system
comes equiped with a built in let
off adjustment perfect for Bow
Hunting or Bow Fishing. Simply
move your module screws to the
FISH symbol and take advantage
of a low let off draw.
STANDARD
LET OFF
(HUNTING)
LOW LET OFF
(FISHING)