Intercom/keypad specifications, Hole template for mounting the base unit – Mighty Mule FM136 User Manual

Page 8

Advertising
background image

6

rev - 09-20-10

base unit is at least 30 feet.

3. Press the “ID SET” button on the keypad until you hear a beep, then release. This erases all stored ID Codes.
4. Press the “ID SET” button on the MASTER base unit for approximately 2 seconds then release. You will hear ONE

beep from the base unit and TWO from the keypad, which means the ID Codes are reassigned.

5. Test the system by pressing the CALL button on the keypad to see if the base unit receives the signal. Once the system

is working, you will need to reset additional base stations (see page 5).

If all connections are correct and the ID SET change didn’t solve the communication problem, please call our Technical

Service Department at 1-800-543-1236, Monday–Friday, 8:00 am to 7:00 p.m. (ET).

INTERCOM/KEYPAD SPECIFICATIONS

Frequency

318 MHz from keypad to gate opener
900 MHz from keypad to base station

Memory – Keypad

Stores up to 25 four-digit entry codes

Power Consumption – Keypad

60 mA when relay is closed

Power Supply – Keypad

8-24 Vdc or four AA batteries

Power Supply – Base Unit

9 Vdc 300 ma transformer; 3.6V Ni-MH 800 mA
rechargeable battery pack

Range from Keypad to Base Unit

500’ wireless

Range from Reypad to Gate Opener

50’ wireless 100’ wired using 16 AWG wire

Relay Output – Keypad

Momentary, normally open dry contact closes for 2
seconds upon activation

Relay Output Rating – Keypad

12 or 24 Vdc 100 mA

Wiring – Keypad Power & Relay Output

16 AWG stranded low voltage direct burial wire

Limited One Year Warranty

Gates That Open, LLC (“GTO”). gate opener accessories are warranted by the manufacturer against defects in workmanship for a period of one (1) year from the date of

purchase, provided recommended installation procedures have been followed.
In the case of product failure due to defective material or manufacturer workmanship within the one (1) year warranty period, the accessory will be repaired or replaced

(at the manufacturer’s option) at no charge to the customer, if returned freight prepaid to GTO - Gates That Open, LLC • 3121 Hartsfield Rd. • Tallahassee, FL 32303.

IMPORTANT: Call 850/575-4144 or fax 850/575-8950 for a Return Goods Authorization (RGA) number before returning goods to factory. Products received at

the factory without an RGA will not be accepted. Replacement or repaired parts are covered by this warranty for the remainder of the one (1) year warranty period. GTO

will pay the shipping charges for return to the owner of items repaired.
The manufacturer will not be responsible for any charges or damages incurred in the removal of the defective parts for repair, or for the reinstallation of those parts after

repair. This warranty shall be considered void if damage to the product(s) was due to improper installation or use, connection to an improper power source, tampering, or

if damage was caused by lightning, electrical power surge, wind, fire, flood, insects, or other natural agent.
After the one (1) year warranty period, GTO or one of its authorized service centers will make any necessary repairs for a nominal fee. Call GTO at 850/575-4144 for more

information. This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. This warranty is in lieu of all other war-

ranties, expressed or implied. NOTE: Verification of the warranty period requires copies of receipts or other proof of purchase. Please retain those records.

If you have any questions or concerns, please contact our Technical Service Department

Monday thru Friday 8:00 a.m. to 7:00 p.m. (ET) at 1-800-543-1236 or 850-575-4144

GTO–Gates That Open, LLC • 3121 Hartsfield Road • Tallahassee, Florida 32303

Telephone (850) 575-0176 • Fax (850) 575-8912 • www.gtoinc.com

Hole Template for Mounting the Base Unit

Advertising