Mighty Mule FM352 - Manual (Page 41)

M i g h t y M u l e 3 5 2
37
Step 3
With the gate in the fully closed position and the opener retracted, swing the opener to the gate. Mark
reference points for bolt holes on gate cross member through middle of gate bracket slots. The opener
must be level. (Some vertical adjustment is possible by sliding the post bracket assembly up and down.)
Drill
3 / 8 " holes into the gate cross member as marked. Fasten gate bracket to cross member using (2)
3/8" x 3" bolts, washers, lock washers, and nuts. Attach the opener to the post bracket assembly and gate
bracket using clevis pins, bushings, and hairpins clips.
Step 4
Make sure the control box power switch is OFF. Use a small
screwdriver to move the Number 1 DIP switch from the factory
setting (OFF / Pull-To-Open) to ON for Push-To-Open. Turn
power switch ON. The control board is now configured to
push the gate open.
Setting the Open Position Limit
Step 1
Confirm that the power switch is in the ON position, and the gate is in the CLOSED POSITION.
Step 2
Activate your opener by pressing the entry transmitter. Your gates should now be moving from the fully
CLOSED POSITION toward the opening position. Press the transmitter again to stop the gate at the desired
OPEN position. Note: whichever gate reached its desired open position first that will be the first one to be
programmed.
• If the second arm is stopped at the desired open position,
press the
'SET LIMIT' on the SECOND ARM FOR 5 SECONDS.
• If the master arm is stopped at the desired open postion,
press the
'SET LIMIT' on the MASTER ARM FOR 5 SECONDS.
Operator
Fence Post Gate Post and Gate Cross Member
(In Closed Position)
POST PIVOT BRACKET level with the
horizontal surface of the GATE BRACKET
LEVEL
LEVEL
LEVEL
1 ON
2
3
4
15
CHARGING
POWER
STATUS
RF
PULL-PUSH
MODE1
MODE2
LOCK/BEACON
OFF 120
MIN MAX
STALL FORCE
CLOSE TIME
SET
LIMIT
LEARN
REMOTE
AUX OUT
SOLAR
PANEL
18VAC
RCVR
GRN BLK RED EXIT
SAFETY
EDGE CY
CLE
COMMON
LINK
1
ON
2
3
4
PULL-PUSH
MODE1
MODE2
LOCK/BEACON