Mighty Mule FM130 - Manual (Page 5)

Wireless Vehicle Sensor rev. 02-18-12 3
RF
GRN BLK RED EXIT
SAFETY
EDGE
CY
CLE
COMMON
LINK
ON
ALARM ACCESSORY RCVR
SEQ1
SEQ2
LEARN
BLU ORG WHT GRN R B G
COM COM
CY
CLE
CL
OSE
SAFETY EXIT/ OPEN SHADOW LOOP CL
OSE
EDGE OPEN EDGE
BLK GRN RED
STALL FORCE
MI
N
M
AX
These GREEN control boards require the RB709U-NB Receiver.
RCVR
Do You Need to Install the Receiver?
IMPORTANT: The RB709U-NB Universal Receiver (included) is designed, and necessary, to work with
certain models of GTO/Mighty Mule Gate Opener control boards.
Many models do not require the use
of the Receiver. To determine if you will need to install the Receiver, remove the gate opener control box
cover and examine the control board.
If your control board matches any of the illustrations above, you WILL need to install the Receiver (refer to the
instructions on page 4).
If your control board DOES NOT match any of the illustrations above, proceed to #4 “Test the System.”
4. Test the System
Step 1: Make sure gate opener is turned ON and gate is in the closed position.
Step 2: Install 2 “AA” batteries (included) in the Transmitter Module; the gate will open. Wait 60 seconds before
proceeding to the next step and
DO NOT move the sensor, any vehicles, or metal objects that are within 25 ft. during
this calibration/”self-test” 60-second period.
Step 3: Use your Entry Transmitter to close the gate. Test the Wireless Vehicle Sensor by driving
your vehicle past the Sensor at normal driveway speed. The gate should open each time; if it does
not, use a small screwdriver to increase the Sensitivity Adjustment (clockwise rotation).
Step 4: Once operation is satisfactory, turn the gate opener OFF. Fill the holes and trench with soil
and tamp firm. The bottom third of the Mounting Post should be buried firmly in the ground.
Step 5: Turn the gate opener ON and make sure gate is in the closed position. Replace Transmitter
Module cover and test the system again (Step 3). NOTE: Do not cover the Transmitter Module with anything metal, as
this will cause signal interference.
Your installation is now complete. If your Wireless Vehicle Sensor is not working properly, please refer to the
Troubleshooting Guide on the back cover of this Installation Manual.
GTO WIRELESS EXIT WAND
TRANSMITTER
MIN MAX
SENSITIVITY