MK Plastics KVC IO&M - Manual (Page 9)

M.K.Plastics Corp. Montréal, Québec www.mkplastics.com 9
NEOPRENE GASKET
(BY M.K. PLASTICS)
AXIJET-V MOUNTING CAP
PLENUM MOUNTING CAP
MOUNTING HARDWARE
(BY M.K. PLASTICS)
NEOPRENE GASKET
(BY M.K. PLASTICS)
PLENUM
STACK/WINDBAND
ASSEMBLY
TRANSITION
(DEPENDING ON FAN SIZE)
AXIJET-V
NEOPRENE GASKET
(BY M.K. PLASTICS)
AXIJET-V MOUNTING CAP
PLENUM MOUNTING CAP
MOUNTING HARDWARE
(BY M.K. PLASTICS)
NEOPRENE GASKET
(BY M.K. PLASTICS)
PLENUM
STACK/WINDBAND
ASSEMBLY
TRANSITION
(DEPENDING ON FAN SIZE)
AXIJET-V
NEOPRENE GASKET
(BY M.K. PLASTICS)
AXIJET-V MOUNTING CAP
PLENUM MOUNTING CAP
MOUNTING HARDWARE
(BY M.K. PLASTICS)
NEOPRENE GASKET
(BY M.K. PLASTICS)
PLENUM
STACK/WINDBAND
ASSEMBLY
TRANSITION
(DEPENDING ON FAN SIZE)
AXIJET-V
NEOPRENE GASKET
(BY M.K. PLASTICS)
AXIJET-V MOUNTING CAP
PLENUM MOUNTING CAP
MOUNTING HARDWARE
(BY M.K. PLASTICS)
NEOPRENE GASKET
(BY M.K. PLASTICS)
PLENUM
STACK/WINDBAND
ASSEMBLY
TRANSITION
(DEPENDING ON FAN SIZE)
AXIJET-V
NEOPRENE GASKET
(BY M.K. PLASTICS)
AXIJET-V MOUNTING CAP
PLENUM MOUNTING CAP
MOUNTING HARDWARE
(BY M.K. PLASTICS)
NEOPRENE GASKET
(BY M.K. PLASTICS)
PLENUM
STACK/WINDBAND
ASSEMBLY
TRANSITION
(DEPENDING ON FAN SIZE)
AXIJET-V
Figure-5. Axijet-V Fan Installation (KVC – Similar)
Axijet-V/KVC to Plenum Installation
1. Place the 1” wide x 1/8” thick neoprene gasket along the top of the plenum mounting cap
(isolation damper housing).
2. Lower the Axijet-V into place using a suitable hoist and chains. All Axijet-V fans come with lifting
lugs.
3. Align the pre-drilled holes in the fan mounting cap and the top plenum mounting cap. Make sure
the gasketing is compressed.
4. Secure with stainless steel hardware, provided by M.K. Plastics.
Discharge Stack/Windband or Velocity Cone Assembly
1. Place the 1” wide x 1/8” thick neoprene gasket along the flanges for the fan outlet, transition (if
supplied) and stack/cone. The transition may already be attached to the stack, depending on fan
size.
2. NOTE: On Axijet-V fans, the discharge stack flange hole pattern is not symmetrical, please align
the bolt holes to match those on the fan discharge flange. This allows the bifurcated opening of
the stack to line up a certain way.
3. Using a suitable hoist and straps around the outside of the stack bifurcated section, lift the
assembly onto the fan outlet flange.
4. Secure with stainless steel hardware, provided by M.K. Plastics.
NOTE: On KVC fans, the
discharge stack is replaced
with a velocity cone.