NEMO Equipment ASASH - Manual (Page 4)

Accessories (Sold Separately)
Several accessories are available for Asashi™ to add comfort or
longevity to your tent.
Asashi™ Footprint
To install the Asashi™ Footprint, attach the clips at the four
corners of the Footprint to the corresponding Jake's Foot at the
corners of the tent. This will protect the floor of your tent from
abrasion and add to the lifespan of your tent. Make sure the
Footprint is not exposed under the tent shell or it could collect
water in a rain storm. You can also unclip the tent from the Jake's
Feet and use only the fly and Footprint to make a lightweight “On
the Fly” shelter as shown below.
Asashi™ Pawprint™
To install the Pawprint™, snap its corners to the snaps in the
inside corners of the tent. The Pawprint™ can stay attached to
Asashi™ when the tent is packed. If you want to remove the
Pawprint™, use the finger loops to help unsnap the corners.
8. Place the grommets over the ends of the ridge poles using the
finger loops to help.
7. Lay the fly over the inner tent with the shiny side down. Align
the seams with the poles and clip the corners to the ends of each
Jake’s Foot.
10. In extreme weather, attach the supplied guy lines to the
reflective guy-out loops on the rain fly and stake in place.
11. Place your headlamps in the Light Pockets™ to create an
even glow inside your tent.
5. Insert the ends of the ridge poles through the short side pole
sleeves and into the grommets on the sides of the tent. Use the
finger loops to help pull the webbing on and off the pole tips.
This will complete the setup of the inner mesh tent.
9. Stake out the vestibule anchors. Adjust the webbing straps on
each anchor to create an even tension throughout the entire
tent.
5 5
9 10
7 8