NEMO Equipment ASASH - Manual (Page 5)

1. To take down Asashi™, first remove the fly by twisting off the
corner clips and pulling on the finger loops to release the poles
from the grommets. Shake off any moisture. Water will add
weight to your pack and can lead to mildew.
2. Empty the inner tent and remove accessories (including the
Footprint and Pawprint™). Shake out moisture and debris.
Remove the ridge poles from the grommets using the finger
loops. Slide the poles out from inside the pole sleeves.
3. Twist the Jake's Foot corner anchors to detach the main poles
and slide the main poles out from inside the pole sleeves. Fold all
of the poles and store them in the pole pocket of the stuff sack.
4. With your foot on the accessory pocket of the stuff sack, stuff
the tent and fly into the large mesh pocket.
6. Remember to leave no trace even in winter. Before leaving
your campsite take a thorough look around making sure you
have not left anything behind, out of place, or damaged.
5. Roll up the stuff sack, securing it with the compression straps.
The Asashi stuff sack also works very well as a hanging drying
bag when not in carrying the tent.
Tent Take Down
Storage
Remember to dry your tent out completely before storing as
moisture can lead to mildew. Also try to remove as much dirt and
debris from your tent as possible. Avoid storing your tent
compressed or exposed to UV light for long periods.
1 1
5 4
Asashi™ Gear Loft
To install the Asashi™ Gearloft, first attach the clip on the
webbing to the loop at the center of your ceiling inside the tent.
Then attach the four corner clips to the corresponding webbing
loops on the tent. Use the cord-lock to adjust the height of your
gear loft. The lowest position is ideal for storing gear on top of the
loft. The highest position is ideal for getting the loft out of the
way and for using the gear pockets on the underside of the loft.
Asashi™ Link™
To install the Asashi™ Link™, first unzip and disconnect the front
vestibules of each tent. Note: The zipper will release on the right
side when facing the tent. Then connect the Link™ by zipping
one side to each tent fly. Make sure to close the snaps at the end
of the zippers. Stake the tents in place to create the proper
tension in the Asashi™ Link™.
Asashi™ Garage™
To install the Asashi™ Garage™, first unzip and disconnect the
front vestibule from the tent. Note: The zipper will release on the
right side when facing the tent. Then connect the Garage™ by
zipping it to the tent fly. Make sure to close the snaps at the end
of the zipper. Put the pole through the pole sleeve inside the
front of the Garage™ and place the ends through the grommets
in webbing. Connect the side release buckle and stake the front
anchors in place.