Paradigm Soundtrack 2 System - Manual

Remote Control What’s in the box . . .
Soundbar power
cord (2 pieces)
Soundbar
Removable grille
Soundbar feet
‘AAA’ batteries for remote
Mute
Volume Down
Volume Up
Play/Pause
Next Track Previous Track
Enable
Bluetooth
Source
Power On/Off
Soundbar on-wall brackets
Subwoofer feet and screws
Subwoofer
with cradle
(Adaptor for use when sub
is in horizontal position,
wired connection only)
#2 Phillips (not supplied)
Remote
110413
Set-Up Guide
The Official Sound of YOU
™
Subwoofer
power cord
Optical cable
(digital)
A
Dual RCA cable
(analog)
B
C
D
Your Soundtrack 2 System is capable of
learning codes from remote controls you are
using for other sources. See manual for details.
ATTENTION: remove
protective end caps
Music Mode*
* Sonic enhancements
to listening experience
according to mode
Movie Mode*
Greyed out buttons do
not apply to this model
FUNCTION AND OPERATION
System OFF: Press POWER
System ON: Press POWER
Auxiliary 3.5 mm Stereo Source:
Press SOURCE once
Analog RCA Source: Press SOURCE a second time
Digital Optical Source: Press SOURCE a third time
Bluetooth Wireless Connection: Press SOURCE
a fourth time (see Bluetooth connection for details)
Wireless Soundbar / Subwoofer Connection: Press SYNC.
LED flashes and stops flashing once there is a connection
Volume Up/Down: Press UP ARROW or DOWN ARROW
Max Volume: When volume is set to maximum level
the LED brightness increases and flashes rapidly
Min Volume: When volume is set to minimum level
the LED brightness increases and flashes rapidly
LED
Bluetooth Connection
1. FIRST TIME CONNECTION: To connect a phone/tablet that HAS NEVER
been connected to the Soundtrack 2, press the Enable Bluetooth
button on your remote or press the Source button (multiple times if
necessary) on the top-panel of the soundbar until the soundbar LED
rapidly flashes RED then BLUE ( ). The connection
process will take approximately 1 minute. See Step 2.
PREVIOUSLY CONNECTED: If your phone/tablet HAS previously
been connected to Soundtrack 2, the LED will flash RED then
BLUE ONCE ( ). Select Bluetooth as your playback
option and skip step 2.
2. While the LED on the soundbar alternates between RED and BLUE
( ), enable Bluetooth on your phone/tablet and search for
“Soundtrack 2” on your Bluetooth device list. Select “Soundtrack 2” to
establish a connection. Once a connection is established, the LED
illuminates Solid Blue ( ). Depending on phone/tablet you may
need to change the playback device to “Soundtrack 2” or it may
change automatically.
x1
x2
x1 x1
x3
-
+
-
+
rapid
rapid
rapid
Manufactured under license from Dolby Laboratories. Dolby and the double-D symbol are trademarks
of Dolby Laboratories.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and
any use of such marks by Paradigm Electronics Inc. is under license.
The “aptX® software is copyright CSR plc or its group companies. All rights reserved. The aptX®
mark and the aptX logo are trade marks of CSR plc or one of its group companies and may be
registered in one or more jurisdictions.”
For more information visit paradigm.com/shift
™
MODE
Functions and LED Indication
MODE
EN_Soundtrack_2_Set-Up_Guide.indd 1 13-11-04 5:18 PM