Step 3 step 4 – ParkZone PKZ1600 User Manual
Page 4
4
Attaching the Wing
In order to attach the wing of your Focke-Wulf 190,
please follow these simple instructions:
1. Locate the included wing screws (in clear plastic
bag).
2. Plug in the aileron servo lead from the wing into
the aileron extension. This is very important, as
the ailerons will be reversed if this is not done.
3. Carefully attach the wing to the fuselage. Use 3
screws to secure the wing as shown.
Attaching the Horizontal Stabilizer
1. Locate the horizontal stab of the tail.
2. Slide the horizontal tail stab through the allotted
space in the fuselage, making sure the control
horn attached to the horizontal tail stab will prop-
erly align with pushrod and clevis exiting the back
of the fuselage.
3. When you are certain the tail is centered correct-
ly, use the provided clear tape to properly secure
the tail to the fuselage, as shown. Use the tape
Step 3
Step 4
������
������
on the top and bottom of each side of the tail
(total of 4 applications).
4. Make sure that the throttle slider is all the way
down, in the “off” position. Turn on the transmit-
ter and plug in the flight battery. Make sure the
trim levers and control stick are centered.
5. Locate where the clevis and rod exit the fuse-
lage, and attach the clevis to control surface as
shown.
6. Make necessary trim adjustments prior to flight.
See step 5 for instructions on how to do this.
tape
Center of Gravity Information
The center of gravity (CG) of the ParkZone FW 190 is approximately 5
3
/
4
” forward from the trailing edge of the
wing. You will notice two panel lines at this location and the CG is between those lines. This is for both the stock
9 cell Ni-MH and also a 3S LiPO pack.
You can confirm this by placing your fingers between these panel lines and balancing the plane while it is inverted.