ParkZone PKZ6980 - Manual (Page 5)

EN
Battery Selection
• We recommend the E-fl ite ® 1800mAh 11.1V 3S 30C Li-Po (EFLB18003S30).
• If using another battery, the battery must be at least an 1800mAh battery.
• Your battery should be approximately the same capacity, dimensions and
weight as the E-fl ite Li-Po battery to fi t in the fuselage without changing the
center of gravity a large amount.
1. Lower the throttle and throttle trim to the lowest settings. Power on the
Transmitter, then wait 5 seconds.
2. Push the button (A) into the fuselage and remove the battery hatch.
3. Remove the battery hatch and install the battery (B) all the way to the
front of the battery compartment. See the Adjusting the Center of Gravity
instructions for more information.
4. Make sure the fl ight battery is secured using the hook and loop strap (C).
6. Connect the battery to the ESC and keep the aircraft immobile on its
wheels away from wind for 5 seconds.
• The ESC will sound a series of tones (refer to step 5 of the binding
instructions for more information).
• An LED will light on the receiver (the red, blue and green gain LEDs will
also fl ash).
If the ESC sounds a continuous double beep after the fl ight battery is con-
nected, recharge or replace the battery.
For further explanation of the gain lights, refer to the “Initializing the AR635”
section of the AR635 receiver manual.
6. Reinstall the battery hatch. Push the rear of the battery hatch securely to
ensure the latch is fully engaged.
Battery Installation and ESC Arming
B C
The Spektrum AR635 receiver is recommended for ths airplane. If you choose
to install another receiver, ensure that it is at least a 6-channel full range
(sport) receiver. Refer to your receiver manual for correct installation and
operation instructions.
1. Remove the canopy from the fuselage.
2. Install your full range (sport) receiver in the fuselage using double-sided
servo
tape.
3. Attach the elevator and rudder servo connectors to the appropriate
channels of the receiver.
4. Attach the aileron Y-harness to the aileron channel of the receiver.
5. Attach the ESC connector to the throttle channel of the receiver.
Receiver Selection and Installation
5