ParkZone PKZU1280 - Manual (Page 7)

7 EN
Prefl ight Checklist
Installing the Flight Battery and Arming the ESC
9
1. Charge the fl ight battery.
2. Install the fl ight battery in the
aircraft (once it has been fully
charged).
3. Bind the aircraft to the transmitter
(BNF only).
4. Make sure the linkages move freely.
9
5. Perform the Control Direction Test
with the transmitter.
6. Adjust the center of gravity.
7. Find a safe and open area.
8. Plan fl ight appropriate for fl ying
location.
Arming the ESC also occurs after binding
as previously described, but subsequent
connection of a fl ight battery requires the
following steps.
CAUTION: Always keep hands away
from propeller. When armed, the motor will
turn the propeller in response to any throttle
movement.
CAUTION: Always disconnect the Li-Po
battery from the aircraft receiver when not
fl ying to avoid over-discharging the battery.
Batteries discharged to a voltage lower than
the lowest approved voltage may become
damaged, resulting in loss of performance and
potential fi re when batteries are charged.
1
3
2
Lower throttle
and throttle
trim to lowest
settings.
Power ON
the
Trans-
mitter, then
wait
5
seconds
Secure the
battery to the
hook and loop
strip on the
battery holder.
Connect the
battery to the
ESC, noting
proper polarity.
Continuous
LED