ParkZone PKZU2180 - Manual (Page 16)

16
EN
Limited Warranty
What this Warranty Covers
Horizon Hobby, Inc. (“Horizon”) warrants to the
original purchaser that the product purchased (the
“Product”) will be free from defects in materials
and workmanship at the date of purchase.
What is Not Covered
This warranty is not transferable and does
not cover (i) cosmetic damage, (ii) damage
due to acts of God, accident, misuse, abuse,
negligence, commercial use, or due to improper
use, installation, operation or maintenance, (iii)
modifi cation of or to any part of the Product, (iv)
attempted service by anyone other than a Horizon
Hobby authorized service center, (v) Product not
purchased from an authorized Horizon dealer, or
(vi) Product not compliant with applicable
technical regulations.
OTHER THAN THE EXPRESS WARRANTY ABOVE,
HORIZON MAKES NO OTHER WARRANTY OR
REPRESENTATION, AND HEREBY DISCLAIMS ANY
AND ALL IMPLIED WARRANTIES, INCLUDING,
WITHOUT LIMITATION, THE IMPLIED WARRANTIES
OF NON-INFRINGEMENT, MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE. THE
PURCHASER ACKNOWLEDGES THAT THEY ALONE
HAVE DETERMINED THAT THE PRODUCT WILL
SUITABLY MEET THE REQUIREMENTS OF THE
PURCHASER’S INTENDED USE.
Purchaser’s Remedy
Horizon’s sole obligation and purchaser’s sole
and exclusive remedy shall be that Horizon will,
at its option, either (i) service, or (ii) replace, any
Product determined by Horizon to be defective.
Horizon reserves the right to inspect any and all
Product(s) involved in a warranty claim. Service
Problem Possible Cause Solution
LED on receiver
fl ashes rapidly
and aircraft will
not respond
to transmitter
(after binding) Less than a 5-second wait between fi rst
powering on transmitter and connect-
ing fl ight battery to aircraft Leaving transmitter on, disconnect and
reconnect fl ight battery to aircraft
Aircraft is bound to a diff erent model
memory (ModelMatch
TM radios only)
Select correct model memory on trans-
mitter and disconnect and reconnect
fl ight battery to aircraft
Flight battery/transmitter battery
charge is too low Replace/recharge batteries
Control surface
does not move Control surface, control horn, linkage or
servo damage Replace or repair damaged parts and
adjust controls
Wire damaged or connections loose Do a check of wires and connections;
connect or replace as needed
Flight battery charge is low Fully recharge fl ight battery
Control linkage does not move freely Make sure control linkage moves freely
Controls re-
versed Transmitter settings reversed Do the Control Direction Test and adjust
controls on transmitter appropriately
Motor loses
power Damage to motor or power components Do a check of motor and power compo-
nents for damage (replace as needed)
Nut on prop shaft is too tight Loosen prop shaft nut until propeller
shaft turns freely
Motor power
quickly decreas-
es and increases
then motor
loses power Battery power is down to the point of
receiver/ESC Low Voltage Cutoff (LVC) Recharge fl ight battery or replace battery
that is no longer performing
Servo locks or
freezes at full
travel Travel adjust value is set above 100%
overdriving the servo Set Travel adjust to 100% or less and/or
set sub trims to Zero and adjust linkages
mechanically.
Troubleshooting Guide (continued)