ParkZone PKZU2480 - Manual (Page 11)

11 EN
The CG location is 35mm back from the leading
edge at the wing root.
This CG location has been determined with the
included 1S 150mAh 3.7V Li-Po battery installed in
the battery cavity.
Balance the model on the edge of a metal ruler to
fi nd the Center of Gravity. Place the ruler on the
underside of the airframe.
Adjusting the Center of Gravity (CG)
35mm
Control Rates
We recommend using a DSM2/DSMX aircraft
transmitter capable of dual rates. Adjust according
to individual preferences after initial fl ight.
To achieve the proper Low Rate settings when
using a programmable DSM2/DSMX aircraft
transmitter, set the low rate value to 70% for the
aileron, elevator and rudder.
NOTICE: Do not set your transmitter travel
adjust over 100%. If the TRAVEL ADJUST is
set over 100%, it will not result in more control
movement, it will overdrive the servo and cause
damage.
High Rate Low Rate
Aileron 100% 70%
Elevator 100% 70%
Rudder 100% 70%