Peg-Perego Primo Viaggio 4-35 User Manual
Page 30
- 30 -
Thread the lap portion of the belt through
the slots on the base (c) and lock the latch
plate into the buckle as shown (d). Press
down on the base with your body weight
and pull the shoulder strap as shown (e).
Take the shoulder portion of the belt and
tread it through the openings again (f).
Close the Right Tight lockoff clip by
pressing the lever as shown in the picture
(g) with an audible click. Push and pull
on the base. If you can move the base
more than 2,5 cm (1 inch), tighten the belt
further. Check the level indicator. If the
bubble has moved outside of the desired
area, turn the knob until it is back within
the correct area. You may need to loosen
the strap slightly to do this.
Warning! If you cannot get the belt tight
enough, refer to your vehicle manual for
instructions on how to secure the base using
the type of seat belt in your vehicle. Your
baby is not safe riding in a loose car seat.
How to install the Base using your VEHICLE SEAT BELT