Portable Winch Gas-powered portable capstan winch PCW3000 - Manual (Page 8)

8
3.3 Winch anchor
OPTION 1: In most cases, the winch is anchored to a fixed point using the included polyester
sling or with optional anchoring devices and the rope end is tied to the object you want to move.
The load is moving towards the winch when you pull the rope.
OPTION 2: Alternately, the winch can be anchored to the load that needs to be moved and the
rope end is tied to a fixed point. The winch and the load are therefore pulled toward the fixed
point where the rope end is tied. This method is useful when you need to guide the load while
you operate the winch.
3.3.1 Using the polyester sling (included with the winch)
Go around the anchor point with the sling. Insert each end of the sling in one of the safety hooks
located on the winch (figure 1 below).
Position the winch in line with the load. When the winch is under tension, it will try to align itself
with the load. The friction of the sling against the anchor point could prevent correct alignment. If
that is the case, release the tension on the rope and position the sling on the anchor point so
that the tension is equally distributed on both winch anchor hooks.
DON’T DO THIS! WHEN YOU ANCHOR THE WINCH, MAKE SURE
THAT YOU DO NOT DO A COMPLETE WRAP AROUND THE ANCHOR POINT (FIGURE 2
BELOW). THIS SET-UP WILL PREVENT PROPER ALIGNMENT OF THE WINCH WITH THE
LOAD AND WILL PUT UNEVEN TENSION ON THE WINCH ANCHOR HOOKS.
AVOID INSTALLING THE SLING ON SHARP EDGES THAT MIGHT
DAMAGE IT. WHETHER YOU ARE USING A POST, A TREE OR A STUMP, ALWAYS
INSTALL THE SLING NEAR THE
ANCHOR’S BASE.
USING A STUMP AS AN ANCHOR POINT MEANS PAYING SPECIAL
ATTENTION IN ORDER TO PREVENT THE SLING FROM SLIPPING OVER IT.
MAKE SURE THE ANCHOR POINT IS STRONG ENOUGH TO RESIST
THE PULL WITHOUT BREAKING OR BEING DAMAGED.