Portable Winch Gas-powered portable capstan winch PCW3000 - Manual (Page 9)

9
3.3.2 Using the hitch plate winch anchor (PCA-1261) for tow balls up to 50 mm (2'')
diameter
1) Figure 1: Push the safety hooks in the rectangular openings of the hitch plate. The rubber
plate must be under the winch;
2) Figure 2: Start the winch engine;
3) Figure 3: Slide the plate on the ball hitch and pull the winch forward;
4) Figure 4: Wrap the rope around the drum and start winching. The winch will align itself
automatically with the load.
USE THE HITCH PLATE ONLY WITH CATEGORY II BALL HITCH (1500
KG (3300 LB)) OR HIGHER. MAKE SURE THE ANCHOR
ING VEHICLE’S HAND BRAKE IS ON
AND WORKING PROPERLY. POSITION BLOCKS BEHIND THE WHEELS TO PREVENT
ROLL BACK.
3.3.3 Using the winch support plate (PCA-1268) with square tubing 50 mm (2'') (PCA-1267)
1) Figure 1, no. 1: Slide the square tubing (PCA-1267) into the vehicle
’s receiver and secure
it with both the hitch pin and the ‘’R’’ pin;
2) Figure 1, no. 2: Slide the winch support plate (PCA-1268) onto the square tubing and
s ecure it with both the hitch pin and the ‘’R’’ pin;
Note: Its lateral movement can be adjusted by positioning the bolts into the square holes;
3) Figure 2: Attach the winch anchor hooks to the eye bolts;
4) Figure 2: Wrap the rope around the drum and start winching. The winch will align itself
automatically with the load.