Portable Winch High Speed gas-powered pulling winch PCW5000-HS User Manual
Page 12
12
IF YOU NEED TO PULL DOWNWARD, YOU WILL NEED TO INSTALL
EITHER A PULLEY OR A ROLLER TO PREVENT DAMAGE TO THE WINCH SUPPORT
PLATE.
MAKE SURE THE ANCHOR
ING VEHICLE’S HAND BRAKE IS ON AND
WORKING PROPERLY. POSITION BLOCKS BEHIND THE WHEELS TO PREVENT ROLL
BACK.
3.3.5 Using the tree/pole mount with anchor strap (PCA-1263)
The tree/pole mount is intended to use with either the winch support plate (PCA-1268) or the
vertical pull winch support (PCA-1264). Therefore, you must first install the tree/pole mount. To
do this, follow these steps:
1) Figure 1: Place the t
ree/pole mount at the base of the tree or pole. Insert the sling’s hook
into the anchor point on the left
; then feed the sling’s end through the ratchet system;
2) Figure 2: Slide the whole set-up upward to the desired height and remove the supplied
wrench;
3) Figure 3: Tighten the sling with the wrench while making sure the rubber pads are
properly positioned. The pads should offer maximum contact surface with the tree or pole.
Figure 19
1