Portable Winch High Speed gas-powered pulling winch PCW5000-HS - Manual (Page 6)

6
Make sure to pull on the recoil starter in the axis of the rope outlet (figure 1 below). If you pull
vertically (figure 2 below) the friction of the rope on the plastic cover might damage the rope
and/or the cover.
2.2.4 Capstan drum
Your Portable Capstan Winch
TM
is equipped with either a 57 mm (2-1/4") or 85 mm (3-3/8")
diameter capstan drum.
If you wish to change the drum, follow these simple installation steps. All bolts require a 4 mm
(5/32") hex wrench, included with your winch manual.
1) Remove the rope guide (figure 1);
2) Remove the bolt located at the end of the drum shaft (figure 2);
3) Remove the original drum from the shaft (figure 3). If necessary, you may push it forward
with two screwdrivers. Make sure that the shaft key stays in place. Install bolt and
washer;
4) Replace it with the new drum (figure 4);
5) Install the rope guide (included with the new drum) using the two (2) bolts.
IMPORTANT: Make sure that the rope guide is not in contact with the capstan drum.