REFCO REF-METER-OCTA - Manual (Page 8)

REF-METER-OCTA User’s Guide English
6
Unpacking the REF-METER-OCTA
1. Remove the REF-METER-OCTA from the carry bag.
2. Push the signed part of the control box to remove it from the storage dock. The storage
dock is placed on the low side of the weighing platform.
3. Pull out the control box from the storage dock. When using the REF-METER-OCTA,
ensure the cable does not touch the top of the weighing platform to avoid inaccuracies.
4. If desired, extend the mounting hook.
Repacking the REF-METER-OCTA
1. If extended, restore the easel of the control box to the retracted position.
2. Hold the control box and press the yellow auto reel button on the side of the platform.
3. Push the control box firmly into the storage dock of the weighing platform until it snaps
in place.
4. Replace the REF-METER-OCTA into the carry bag.
Battery Installation & Replacement
1. Remove the battery cover from the rear of the control box by compressing tab at the
base of the battery cover.
2. If necessary, remove old set of batteries.
3. Insert 4 ‘AAA’. Replace battery cover by aligning tabs and snapping back into place.
IMPORTANT: TO PREVENT DAMAGE TO THE REF-METER-OCTA, CAREFULLY
OBSERVE BATTERY POLARITY AS MARKED INSIDE THE BATTERY COMPARTMENT.
DO NOT LEAVE DEAD BATTERIES INSIDE THE CONTROL BOX. REMOVE
BATTERIES IF THE REF-METER-OCTA IS NOT TO BE USED FOR AN EXTENDED
PERIOD OF TIME.