Front panel – Rocktron Velocity VT60 User Manual
Page 5
2
Front Panel
1
POWER switch
2
CHANNEL SELECT
switch
3
LOOP switch
This switch powers up the Velocity VT60.
This switch selects which channel is currently active (Clean or Distortion).
This switch determines whether the effects loop is currently active.
CLEAN Channel Controls
4 BASS control
5 MID control
6 TREBLE control
7 LEVEL control
8 CLEAN LED
This control determines the amount of low frequency information in the Clean chan-
nel, and is adjustable over a range of ±15dB.
This control determines the amount of mid frequency information in the Clean chan-
nel, and is adjustable over a range of ±15dB.
This control determines the amount of high frequency information in the Clean
channel, and is adjustable over a range of ±15dB.
The LEVEL control determines the output level of the Clean channel, independent of
the Distortion channel.
Note:
The Clean channel LEVEL control drives the input to the tube stage, and can
therefore generate distortion when set to extremely high levels.
To maintain the cleanest channel possible, it is important to set the Master
VOLUME control (17) to higher levels when more volume is required (instead of
changing the individual channel LEVEL controls). The Clean channel LEVEL
control should then be used to set the level of the clean channel relative to the
level of the Distortion channel.
When lit, the CLEAN L.E.D. indicates that the Clean channel is currently active.