Rocktron UTOPIA G300 - Manual (Page 25)

25
The first function displayed after turning the FUNCTION SELECT knob is the Global function. The
parameters provided in this function affect all presets (i.e. the settings stored for these parameters are the
same for all presets).
The PARAMETER SELECT knob will allow you to access these Global parameters:
6. GLOBAL Function
The OUTPUT parameter determines whether the output of the UTOPIA G300 is
a stereo (left and right) signal or two mono signals.
This SPEAKER Simulator parameter under the Global function allows you to
globally (all presets) set the Speaker Simulator into the following modes:
UNLOCK - Bypasses the Speaker Simulator on all presets leaving the outputs
full range.
LOCKOFF - If you have the Speaker Simulator "ON" in the Speaker Simulator
Function the Speaker Simulator will turn on when that preset is selected.
LOCK L (LEFT OUTPUT) - Locks the Speaker Simulator "ON" in the LEFT
OUTPUT and leaves the Right OUTPUT full range. Allows you to use the left
output for direct recording or direct to a PA and the right output to your amp at
the same time to perform live.
LOCK B (BOTH OUTPUTS) - Locks the Speaker Simulator "ON" in both Left
and Right Outputs. This is the ideal setting to use when using headphones.
The HUSH OFFSET parameter allows you to globally (all presets) adjust the
HUSH ® Expander Threshold. This means that if this parameter is altered from
0(dB) to +3(dB), the Expander Threshold will be 3dB higher for all presets. This
feature can be useful when switching from a quiet guitar with passive electron-
ics to a noisy guitar with active electronics, as the active guitar would require a
higher Threshold level in all presets.
The *MASTER VOLUME has a range from -40dBu to +6dBu. This control
adjusts the overall volume of the output and is extremely useful in adjusting the
volume in headphones.
*Note: When the preset title is being displayed the PARAMETER ADJUST con-
trol will provide instant access to modify the MASTER VOLUME anytime.
OUTPUT
SPKR SIM
HUSH OFFSET
MASTER VOLUME
NOTE: If you would like to save any changes made to the GLOBAL PARAMETERS you must STORE
them at this time, before leaving the GLOBAL FUNCTION.