Rupert Neve Shelford 5051 Inductor EQ / Compressor - Manual (Page 13)

13
compression.
LINK IN / OUT
1/4” phone jacks on the back used to connect the compressor VCAs.
The suggested setup for linking multiple units is to do the following:
On the back panel of the left most 5051, plug the link cable into the link out jack. Plug the other end
of the cable into the link in jack of the 5051 to its right. In the same way, connect all of the 5051 units
together.
LINE 1
XLR female transformer balanced floating input associated with the LINE 1 position of the front panel
input switch. Pin 2 high, 10 k Ohm input impedance.
LINE 2
XLR female transformer balanced floating input associated with the LINE 2 position of the front panel
input switch. Pin 2 high, 10 k Ohm input impedance.
OUTPUT
XLR male transformer coupled floating output. Pin 2 high, less than 50 Ohm output impedance.
POWER
Proprietary 4 pin polarized input for +24 and -24V DC power input. This power requirement and
connector is meant to be used with a special shared power supply.
Specifications
Line In
Frequency Response:
Main Output, no load,
–3 dB @ 2.5 Hz
–3 dB @ 125 kHz
Noise:
Measured at Main Output, unweighted, 22Hz-22kHz,
Terminated 40 Ohms, With gain at unity
better than –102 dBu
Maximum input:
from 20 Hz to 20 kHz,
+25 dBu.
Maximum output:
from 20 Hz to 20 kHz is
+25 dBu.
Total Harmonic Distortion and Noise:
from <10 Hz to 80 kHz,
@ 1kHz, +20 dBu output: Better than 0.002%
@ 20Hz, +20 dBu out Better than 0.120%