Simaudio Neo 430HA Headphone Amplifier - Manual (Page 14)

430HA Headphone Amplifier
____________________________________________________________________________________
14
Remote Control Operation
The Nēo 430HA Headphone Amplifier uses the ‘CRM-2’ full-function remote
control (figure 3). It operates on the Philips RC-5 communication protocol
and can be used with other Simaudio MOON components.
The ‘CRM-2’ remote uses two AA batteries (included). To install them,
simply slide the back plate off in the direction of the arrow; insert the
batteries in the correct direction and then replace the back plate.
To engage the ‘CRM-2’ remote for use with the Nēo 430HA Preamplifier,
you must first press the button labeled AMP.
The POWER button located on the upper left will switch the Headphone
Amplifier to either ‘Standby’ or ‘On’ mode.
The DISPLAY button turns the front panel display on and off
The 2 buttons labeled ◄ INPUT ► allow you to sequentially scroll, either
backwards or forwards, through all available inputs. For example, to switch
from the “A1” to the “B1” input, press ◄ INPUT two (2) times. To switch
from the “B1” to the “A1” input, press INPUT ► two (2) times. Pressing and
holding down either of these buttons results in only a single change to the
selected input.
The 2 buttons labeled ▼ VOL ▲ allow you to control the volume level.
Pressing ▼ VOL results in a decrease in the volume level; Pressing VOL ▲
results in an increase in the volume level. You may either press and hold
these buttons down or press them briefly to make volume adjustments.
The MUTE button turns off the output volume. Pressing the “Mute” button a
second time will reinstate the output volume level back to its current setting.
NOTE: The ◄ BAL ► buttons don’t affect the operation of the 430HA.
Figure 3: CRM-2
Remote Control