Simaudio Neo 430HA Headphone Amplifier - Manual (Page 7)

430HA Headphone Amplifier
____________________________________________________________________________________
7
Unpacking
The Nēo 430HA Headphone Amplifier should be removed from its box with care.
The following accessories should be included inside the box with your amplifier:
9 AC power cable
9 ‘CRM-2’ remote control with two ‘AA’ batteries
9 ‘SimLink’ cable with 1/8” mini plug terminations on each end
9 This owner’s manual
9 Warranty and product registration information (USA and Canada only)
Once the Nēo 430HA is unpacked, inspect it
thoroughly and report any damage to your dealer
immediately. We suggest that you keep all of the
original packaging, storing it in a safe, dry place in
case you’re required to transport this product. The
customized packaging is specially designed to
protect the 430HA from any potential damage
during transit.
Please write the serial number of your new Nēo 430HA in the space provided below for future reference.
Serial No.: ________________
Installation & Placement
The Nēo 430HA requires only minimal ventilation
to maintain an optimum and consistent operating
temperature. However, you should avoid placing it
near a heat source as this could compromise the
headphone amplifier’s performance and reliability.
As well, it should be placed on a solid level surface.
The 430HA uses toroidal transformers; even though
they are well shielded, you should not place the
preamplifier too close to source components
sensitive to EMI, such as a turntables.
If your Nēo 430HA is equipped with the DAC
option and you intend to use the USB input
connection (PCM or DSD) with a Windows-
based computer, you will need to install our
USB HD DSD driver, which can be downloaded
from the support section of our website.
Note: Apple-based computers don’t require
this driver.