Sonnox Oxford Restore - Manual (Page 31)

31
“Tune” – In some situations can help to remove musical noise.
“Auto” Mode - Enables automatic updating of noise profile and the noise profile level relative
to the input signal.
“Freeze” Mode – Once you have obtained a good profile, this button will freeze the profile to
prevent it updating.
“Manual” Mode – In this mode, the profile is forced flat. You can then use the Colour, Air or
bias controls to modify the shape of the profile.
“Colour” – Modifies the LF shape of the noise profile.
“Air” – Modifies the HF shape of the noise profile.
DeNoiser Removal Section
“Reduction” – sets the amount of attenuation of broadband noise components below the
threshold.
“HF Cut” – This is a simple low pass filter with a fixed -18dB attenuation. It is active when the
DeNoiser Enable and Master Enable are both active.
“Makeup” – Provides a way to adjust the level of the de-noised signal to compensate for any
loss in level due to the denoising process. This makes it easier to perform with and without de-
noising comparisons using the master IN button.
“Mid/Side” Mode – For stereo inputs, this applies noise reduction to the Side channel. The Mid
channel is unaffected.
“Enable” – If Master Enable is also IN, this makes the broadband DeNoiser active using
glitchless switching.
Display Controls
“Bias Select” – This toggles between the red bias curve that modifies the shape of the noise
threshold profile, and the yellow bias curve that modifies the shape of the noise reduction.