Sonnox Oxford Restore - Manual (Page 8)

8
3.6 Description of Controls
Touch Pad Controls
Several controls in these plug-ins use a Touch Pad associated with a knob or slider. These
controls give a clear display of the SI value of a control, and respond to the following actions:
- Left-Click and drag up/down: Increase/decrease the value
- Right-Click and drag up/down: Fine adjustment of value
- Double Click: Directly edit value
- Shift + Left-Click and drag up/down: Fine adjustment of value
- Control + Left-Click: Set to default
Input and Output Sections
“Meters” – The input and output meters indicate 1dB per segment for the top 18dB of dynamics
range, and 2dB per segment thereafter.
“Trim” – The input trim has a range of +12dB to -12dB. The output trim has a range of 0.0dB to
-12dB
“Listen Audio” – Selects auditioning of the cleaned audio signal.
“Listen Diff” – Selects auditioning of what is being removed from the audio signal.
“Listen Side Chain” – Selects auditioning of the side chain.
“Dialogue Mode” – Selects the Dialogue Mode and displays the Dialogue control panel.
“Master Enable” – With Master Enable selected, all processing is active. If not selected, all
repairs are disabled, although all the detection circuits remain active.
The Master Enable, Audio and Diff buttons all provide smoothly interpolated and glitchless
audio switching. It is advisable to use these for auditioning, rather than using the host
application’s Bypass switch (which is commonly not interpolated).
DePop, DeClick and DeCrackle Sections
“Threshold” – This control is used to adjust a threshold level within the Excitation Profile to
capture an event. If a peak on the Excitation Profile is below the threshold, it will not be