Sonodyne AMC+120P - Manual (Page 7)

100V Line
70V Line
4 ohm voice-coil
P P P
P P P
(Per Channel)
(Per Channel)
OUTPUT DISTANCE WIRE SIZE
AMC+120P / AMC+1202P AMC+250P
100V Up to 50m AWG24(0.2mm2) AWG22(0.35mm2)
50m–200m AWG18(0.75mm2) AWG16(1.5mm2)
Over 200m AWG16(1.5mm2) AWG13(2.5mm2)
70V Up to 50m AWG22(0.35mm2) AWG18(0.75mm2)
50m–200m AWG16(1.5mm2) AWG13(2.5mm2)
Over 200m AWG13(2.5mm2) AWG10(6.0mm2)
4 ohm Up to 10m AWG18(0.75mm2) AWG18(0.75mm2)
10m–30m AWG13(2.5mm2) AWG13(2.5mm2)
Over 30m Not Recommended Not Recommended
NOTE: Only connect one output – either Distributed Line or Low Impedance.
Line Output
The LINE output XLR can be used to connect up to 6 booster amplifiers. Balanced wiring
(shielded pair cable) is recommended.
NOTE: When wiring the LINE output as unbalanced, pin 2 should be wired as hot and pin 1
should be wired as ground/shield. Do not wire pin 3.
Input Connections
For wiring balanced in, pin 2 is hot.
Balanced input wiring (shielded pair cable)
is recommended. Unbalanced RCA wiring
should be keep as short as possible.
Direct Output
The output terminal strip accepts wire sizes from 16-22AWG (1.5mm2 –
0.35mm2) or spade lugs. The following table should be used as a guideline
for cable sizes. Regulations in your area may require different gauged wire
and should be checked before using.
PAGE 7 AMC + SERIES INSTALLATION AND OPERATION MANUAL
INSTALLATION