SOR Submersible Hydrostatic Level Transmitter - Manual

Form 948 (10.09) ©2009 SOR Inc. 1/8
The Series 510 Submersible Level Transmitters are solid state
instruments designed for direct submergence into many types
of liquid for quick, accurate and reliable level measurement.
The transmitter indicates the level of the liquid by continuously
measuring hydrostatic head pres sure using a high performance
ceramic sensor. Electrical connection is made via a 20 gauge
shielded waterproof cable which is vented at the surface to
reference atmos pheric pressure.
Once the transmitter is installed and wired into a control or
display loop, it is ready for use. Before applying power, check
that the supply polarity and excitation volt age is correct.
Series 510
Submersible Level Transmitters
General Instructions
Do not twist the wires during installation or servicing
the instrument as it may break the integrity of the
seal between the wires and the transmitter. Failure of
this nature is not covered by warranty.
Registered Quality System to ISO 9001:2008
NOTE: If you suspect that a product is defective, contact the factory or the
SOR
® Representative in your area for a return authorization number (RMA).
This product should only be installed by trained and competent personnel.
e
MA).
el.
Design and
specifications are
subject to change
without notice.
For latest revision, go to
www.sorinc.com
Table of Contents
Calibration .......................................2
Installation .......................................3
Wiring Details ...................................4
Servicing .........................................5
Fault Conditions .................................5
Typical Fixed Range Installations ............6