Speck Electronics SSM - Manual (Page 54)

Chapter 4 Operation Section
These standard unbalanced 1/4" T.S. jacks allow the interface of an
external stereo signal, such as a DAT, CD player or the output of Specks
"Assign 28" subgroup module.
This recessed stereo trim pot controls the level of program signal (stereo
mix) to the monitor and headphone feeds relative to the cue, click and
aux returns.
There can be four signal sources feeding the monitor and/or headphone
outs; the cue, click, aux and the SSM's stereo mix. As the first three
each have a volume control, it is easiest to think of the Program Trim as
a volume control for the SSM's stereo mix. The nominal setting (factory
preset) for this trim control is fully clockwise.
The main program left/right feed and VU meter levels of the SSM
remain unaffected by this adjustment of the Program Trim.
This pushbutton switch (recessed behind the rear panel) introduces the
solo function, cue, click and aux returns to the master monitor outputs as
well as the headphones.
In the normal position (off), the solo, cue, click and aux returns are
removed, and only the stereo mix is present at the monitor feed. When
this switch is depressed (on), both the monitor and headphone feeds
receive the solo signal, cue, click, and aux returns together with the
stereo mix. The operation of this switch does not affect the program
feed.
24. Aux Return Input Jacks
25. Program Trim Control
26. Solo to Monitor Switch
49